BRAUSSE 1050SE
Automatic Flatbed Diecutting & Creasing Machine with Stripping Station
FEEDER
-
Patent turbo spiral air blower pressing foot at feeder head.
-
Four pick up and four forward suck heads with angle adjustment.
-
Preloading device with rail cart and scaled gate.
-
Non – stop feeder with automatic pile lift.
-
Left and right side turbo air blower.
-
Motorized side adjustment of pallet table.
-
Electrical double sheet control.
-
Fine air blast at the lead edge for smooth thin paper transport.
-
Sheet slow down device of feeder belts to assure an accurate position of the sheet to the front lays with selective on/off switch.
-
Synchronizing device to adjust the sheet positioning to the front lay by hand during production.
-
Bullet catcher on the feeder entrance.
-
Side lays on both sides push and pull convertible.
-
Electronic side lay control to check the sheet position.
-
Four individually adjustable front lays with dial read out at the operation side of the machine.
-
Two electronic front-lay controls by means of Omron Glasfiber Optik to control the sheet arrival.
-
Photo sensor safety barrier at pallet table floor level touching point.
DIE-CUTTING SECTION
-
Precision worm gear crank toggle driving system to ensure smooth and dynamic lower platen movement.
-
Precision stationery upper platen.
-
Sandwich hardened cutting plate.
-
Pneumatic push-button diechase locking mechanism to ensure safe and operator-friendly changing of the die.
-
Pneumatic clutch/brake for main drive system.
-
Servo motor drive impression on/off by push-button.
-
Digital die-cutting pressure tonnage display with maximum pressure limit protection.
-
Seven high precision alloy gripper bar.
-
High-quality pre-stretched gripper bar driving chain.
-
State-of-art 3 cam index gripper bar driving system to ensure smooth and precise gripper bar intermittent movement.
-
Torque limit safety clutch to protect the index driving system in case of gripper bar crash.
-
Double cam-driven gripper opener and front lay swing frame without position restore spring for smooth and accurate sheet register and take off.
-
4+1mm Sandwich Plate with ±1.2mm Micro Adjustment.
-
Air blasting nozzle bar for stretching the thin paper before die-cutting.
STRIPPING SECTION
-
Triple action movement of the upper and lower stripping frames with lower spring-loaded stripping pins.
-
Motorized upper frame suspending hoister.
-
Upper and lower stripping tool mounting frame can be pulled out for job set up and make ready.
-
Remote control operation panel for jogging the upper frame up and down, easy and safe stripping tool set up and alignment.
-
Quick stripping tool exchange device (optional).
-
Mechanical disconnecting of lower stripping frame when it is not in use.
DELIVERY SECTION
-
Automatic delivery with non – stop curtain. This curtain moves into the delivery to catch the arriving sheets during the pile exchange.
-
Five section brush brake each section angle adjustable individually.
-
Air blower to press down the sheets.
-
Rare and side joggers with easy position adjustment.
-
Gripper edge stripping and removing system with a conveyor belt to remove the gripper edge waste sideways to the drive side (Optional).
-
Tape inserter with counter (Optional).
-
Safety device to prevent the steel pile plate from clamping on the foot when it reaches at ground level.