©2019 by EBPack. Proudly created with Wix.com

BRAUSSE 1050SDi 
Automatic Die-cutting Machine with Stripping Station 

 

FEEDER

  • Patent turbo spiral air blower pressing foot at feeder head.

  • Four pick up and four forward suck heads with angle adjustment.

  • Preloading device with rail cart and scaled gate.

  • Non – stop feeder with automatic pile lift.

  • Left and right side turbo air blower.

  • Motorized side adjustment of pallet table.

  • Electrical double sheet control.

  • Fine air blast at the lead edge for smooth thin paper transport.

  • Sheet slow down device of feeder belts to assure an accurate position of the sheet to the front lays with selective on/off switch.

  • Synchronizing device to adjust the sheet positioning to the front lay by hand during production.

  • Bullet catcher on the feeder entrance.

  • Side lays on both sides push and pull convertible.

  • Electronic side lay control to check the sheet position.

  • Four individually adjustable front lays with dial read out at the operation side of the machine.

  • Two electronic front lay controls by means of Omron Glasfiber Optik to control the sheet arrival.

  • Photo sensor safety barrier at pallet table floor level touching point.
     

DIE-CUTTING SECTION

  • Precision worm gear crank toggle driving system to ensure smooth and dynamic lower platen movement.

  •  Precision stationery upper & mobile platen with optimized structure to reduce deformation under pressure hence less make-ready & quick change over.

  •  5mm hardened cutting plate (Hardness HRC 45-50º) with X and Y direction micro adjustment.

  • (±0.9 each way) on top of 15mm base plate with a centerline to ensure precision creaser positioning and quick change over. (4mm+1mm hardened sandwich plate as optional. Hardness HRC 45-50º)

  • Pneumatic push-button diechase locking mechanism to ensure safe and operator-friendly changing of the die.

  • Pneumatic clutch/brake for main drive system.

  • A/C motor drive impression on/off by push-button.

  • Digital die-cutting pressure tonnage display with maximum pressure limit protection of latest technology.

  • Seven high precision alloy gripper bar.

  • High-quality pre-stretched gripper bar driving chain.

  • State of art 3 cam index gripper bar driving system to ensure smooth and precise gripper bar intermittent movement.

  • Torque limit safety clutch to protect the index driving system in case of gripper bar crash.

  • Double cam-driven gripper opener and front lay swing frame without position restore spring for smooth and accurate sheet register and take off.

  • Air blasting nozzle bar for stretching the thin paper before die-cutting.

  • One push-button pneumatic activated safety door of the die-cutting section, more operator friendly.
     

STRIPPING SECTION

  • Triple action movement of the upper and lower stripping frames with lower spring-loaded stripping pins.

  • Motorized upper frame suspending hoister.

  • Upper and lower stripping tool mounting frame can be pulled out for job set up and make ready.

  • Remote control operation panel for jogging the upper frame up and down, easy and safe stripping tool set up and alignment.

  • Quick stripping tool exchange device (optional).

  • Mechanical disconnecting of lower stripping frame when it is not in use.

  • One push-button pneumatic activated safety door of stripping section, more operator friendly. 

DELIVERY

  • Automatic delivery with non – stop curtain. This curtain moves into the delivery to catch the arriving sheets during the pile exchange.

  • Five section brush brake each section angle adjustable individually.

  • Air blower to press down the sheets.

  • Rear and side joggers with easy position adjustment.

  • Gripper edge stripping and removing system with a conveyor belt to remove the gripper edge waste sideways to the drive side.

  • Tape inserter with a counter.

  • Safety device to prevent the steel pile plate from clamping on the foot when it reaches ground level.